RX7 2RTR-1308cc 1.3L MFI (1991)
Acceleration Sensor: Testing and Inspection
Fig. 5 Accelerator Switch Component Test
1.
Disconnect AAS control unit electrical connector.
2.
Connect suitable ohmmeter between terminal N and ground. Ensure continuity is present when accelerator pedal is 3/4 depressed.
3.
If no continuity is present, check for damaged or disconnected wire harness or defective switch, repair or replace as required.
4.
Connect ohmmeter between accelerator switch terminals b and d, Fig. 5. Ensure continuity is present when accelerator is depressed .276-.315 inch.
Replace switch as required.
