RX7 2RTR-1308cc 1.3L MFI (1991)
11. Slide the spring and spacer onto the 5th/Reverse shift rod. While pressing the spacer, install a new clip.
12. Install new clips to the 3rd/4th shift rod and 1st/2nd shift rod.
13. Check to be sure that the centers of the shift fork and clutch hub sleeve are aligned properly.
If they are not, select the proper washer for between 1st gear and the mainshaft front bearing, and between reverse gear and the mainshaft front
bearing.
14. The following washer thicknesses are available.
CAUTION: The total thicknesses of the front and rear washers should be 5.9 mm (0.2323 in) or 6.0 mm (0.2362 in).
