RX7 2RTR-1308cc 80 (1984)
(M/T and A/T)
9. Remove the oil seal with the SST.
Installation
Install in the reverse order of removal referring to the Installation Note.
Installation note
Rear oil seal
1. Apply engine oil to the seal lip.
2. Fit the oil seal onto the stationary gear.
3. Tap the oil seal in evenly using a suitable pipe.
Oil seal outer diameter: 95mm (3.74 in)
Caution
The oil seal must be tapped in until it is flush with the edge of the rear cover.
Flywheel (M/T)
1. Fit the key to the eccentric shaft.
2. Install the flywheel to the eccentric shaft.
3. Apply thread locking compound to the eccentric shaft threads.
4. Apply sealant to the contact surface of the locknut.
