RX7 2RTR-1308cc 80 (1984)
2.
Reconnect the hose to the oil cooler and re-install the oil filter. There should be no oil in the oil pan, oil filter or oil cooler at this time. (fig. 7)
3.
Pour exactly 2-1/2 quarts of oil into the engine.
4.
Start the engine and maintain the engine speed between 1500 and 2000 rpm.
Fig. 8
5.
The Oil Level Warning Light should turn "ON" within 90 seconds after the engine has been started. (fig. 8)
If not, disconnect the coupler from the Oil Level Sensor and ground the disconnected coupler. Check that the warning light turns "ON" while the
engine is idling.
a.
If it turns "ON", replace the Oil Level Sensor and repeat the procedures from step 4 and 5.
b.
If the light does not turn on, the light bulb, fuse and/or related wiring harness should be inspected and repaired.
6.
After verifying that the wiring system is in good working condition, add engine oil to the "F" mark on the dipstick.
