RX7 2RTR-1308cc 80 (1984)
Fig. 13 Adjusting throttle sensor.
4.
If current flows to both terminals, turn adjusting screw counterclockwise until current flows to one side only Fig. 13.
5.
If current does not flow to either terminal, turn adjusting screw clockwise until current flows to one side only.
6.
Install cap onto adjusting screw when adjustment is completed.
Fig. 15 Checking Throttle sensor.
TESTING W/OHMMETER
1.
Disconnect the connector for the throttle sensor.
2.
Connect an ohmmeter to the throttle sensor as shown in Fig. 15.
3.
Open the throttle valve and observe the ohmmeter reading. Throttle opening at idle about 1 kohm, fully open about 5 kohm.