RX7 2RTR-1308cc 80 (1984)
Air Flow Meter/Sensor: Testing and Inspection
Variable Resistor Testing
Fig. 7 Variable resistor test connections. Fuel injected models
1.
Disconnect variable resistor connector and measure resistance between resistor terminals A and C and B and C, Fig. 7. Resistance should be
500-4500 ohms. If resistance is not as specified, replace variable resistor.
2.
Adjust curb idle speed to specification.
Fig. 8 Adjusting variable resistor. Fuel injected models
3.
Adjust variable resistor to obtain highest possible idle speed, Fig. 8.
