RX7 2RTR- 1308cc 1.3L FI (1987)
B)
Vehicle with Old Type Sub-Tank
Install the two water hoses (N320 15 54Y and 9932 50 7650) through the air conditioner pipe hole in the shroud panel.
NOTE:
1.
Apply soapy water to the water hose before installation.
2.
Vehicles without air conditioning require grommet (BA70 61 218) to be installed on the shroud panel for the water hoses to be inserted
through.
CAUTION:
Make sure the water hose is not kinked or bent too sharply.
8.
Replace the level sensor with the modified one and connect the water hose (N320 15 54Y) with the hose clamp (9928 21 301).
CAUTION:
When installing the modified level sensor, turn the level sensor until the rubber seal slightly touches the radiator. Then tighten 3/4 to 1-3/4
turns, aligning the open end of the pipe to the right side. When tightening the sensor, DO NOT turn the sensor counter clockwise to position
the end of the water pipe. You must tighten the sensor beyond the 3/4 turn if necessary to align the water pipe.
9.
Install the two bolts (9979 60 625) and washers (2850 13 332) on the shroud panel (right side). The vehicles equipped with an an conditioner
require replacement of the receiver dryer bracket mounting bolts with new ones (9979 60 625).
