RX7 2RTR- 1308cc 1.3L FI (1987)
Fig. 3 Checking for air at port.
f.
Decrease engine speed to idle and ensure air is sucked into port opening for 8 seconds Fig 3.
Fig. 35 Disconnect throttle sensor.
g. Reconnect throttle sensor connector Fig 35.
h. Increase engine speed and ensure air is not sucked into port when engine speed is greater than 3400---3600 RPM.
i.
Disconnect electrical connector at heat hazard sensor and connect jumper wire to terminals in connector.
j.
Ensure air is not sucked into port at any engine speed.