mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

All Technical Service Bulletins:|1301187 > < Suspension Mode Switch|Testing and Inspection
Page 1
background image

Stabilizer Bar Bracket: All Technical Service Bulletins
Suspension, Rear - Clicking or Sharp Metallic Noise

 Category R
Applicable Model/s 1986-87 RX-7
Subject REAR SUSPENSION SUB-FRAME
Bulletin No.

002/90

Issued

6/8/90

Revised

DESCRIPTION

If a clicking noise or sharp metallic noise is heard from the rear suspension during sudden acceleration from a stop or sudden deceleration on a rough
road, check the left and right sub-frame nuts for proper torque as shown below. Also, if applicable, verify that a washer (P/N 9995 81 426) has been
installed between the stopper washer and the sub-frame nut.
NOTE:
The tightening torque indicated in the 1986 and 1987 RX-7 Workshop Manuals is incorrect. Please make references to this bulletin in these manuals.

All Technical Service Bulletins:|1301187 > < Suspension Mode Switch|Testing and Inspection