RX7 2RTR- 1308cc 1.3L FI (1987)
1.
OPERATION
The EGI control unit needs the following information to control the SIL:
a)
Throttle opening angle (from throttle sensor).
b)
Engine RPM (from ignition coil or crank angle sensor.
c)
Engine load (from air flow meter)
d)
Driving mode (from neutral switch and clutch switch).
e)
Transmission gear position (from 5th gear switch).
f)
Coolant temperature (from water temperature switch - 626 only).
According to the above information, the EGI control unit detects the driving mode and decides whether or not the SIL should illuminate.
II. TROUBLESHOOTING FOR 1986-87 RX-7 (SIL does not illuminate)
(1)
Turn the ignition "ON" and check the SIL.
^
If SIL does NOT illuminate, go to Step (2)
^
If SIL illuminates, go to Step (4)
(2)
With the ignition switch still "ON", ground "1K" terminal (BR Wire) of the EGI Control Unit and check SIL.
^
If SIL does NOT illuminate, check meter fuse (7.5A) or SIL bulb.
^
If SIL illuminates, go to step (3)
