RX7 2RTR- 1308cc 1.3L Turbo FI (1989)
Installing Primary Injector Mixing Plates
1.
When installing the air bleed sockets and mixing plates, be sure they are fully seated and key tab is fitted into locating notch, as shown in
illustration.
Secondary Fuel Rail (Delivery Pipe) And Injector
2.
Always use new insulators and O-rings, and lubricate them with a few drops of clean engine oil prior to installation.
Aligning Primary Injectors By Connector Position
Aligning Secondary Injectors By Connector Position
3.
When installing injectors, be sure injectors are properly inserted at both ends so as not to damage insulators and O-rings. Align injectors by their
connector positions, as shown in illustrations, before tightening down the fuel rails.
4.
Install remaining components in the reverse order of removal, tighten dynamic chamber to manifold nuts and bolts to the specified torque.
14 - 19 ft.lbs (19 - 25 Nm)
