RX7 2RTR- 1308cc 1.3L Turbo FI (1989)
Turn Signal Switch: Service and Repair
1.
On models equipped with airbag, disarm airbag, refer to MAINTENANCE PROCEDURES/AIRBAG ARMING & DISARMING.
2.
On models not equipped with airbag, disconnect battery ground cable.
3.
Remove steering wheel, refer to Steering and Suspension/Steering/Steering Wheel/Service and Repair then the steering column covers.
4.
Disconnect combination switch electrical connectors, and remove stop ring from steering column shaft.
5.
Remove combination switch from steering column.
6.
Reverse procedure to install. Position angle sensor, if equipped, by setting wheels in straight ahead position and aligning alignment marks.
