RX7 2RTR- 1308cc 1.3L Turbo FI (1989)
Flywheel: Technical Service Bulletins
Engine, Rear Oil Seal - Prevent Damage While Assembling
Category
B
Applicable Model/s
1986-'90 RX-7
Subject
ENGINE REAR OIL SEAL
Bulletin No.
007/91
Issued
2/13/91
Revised
DESCRIPTION
Damaging the engine rear oil seal while assembling the flywheel (M/T) or counterweight (A/T) may cause an oil leak. The following countermeasures
have been implemented since February 28, 1990 production.
a)
To prevent damaging the seal, the front edge of the flywheel or counterweight has been smoothed.
b)
The color of the engine rear oil seal has changed from blue to orange. Although the orange seal has a slightly higher tension, the part number
has not been changed, and either seal can be used.
To prevent oil seal damage, follow the Installation Procedure shown below when replacing the oil seal.
VIN OF PRODUCTION CHANGE
JM1FC331 * L0806487
February 28, 1990
JM1FC332 * L0806487
February 28, 1990
JM1FC351 * L0806487
February 28, 1990
INSTALLATION PROCEDURE
1.
Install the new oil seal to the stationary gear.