RX7 2RTR- 1308cc 1.3L Turbo FI (1989)
1. Measure the depth of the main drive gear bearing bore in the clutch housing with vernier calipers.
NOTE: Make this measurement after assembling the transmission case.
2. Measure the main drive gear bearing height.
The difference between the two measurements indicates the required thickness of the adjustment shim.
Standard thrust play: 0 - 0.1 mm (0 - 0.004 in)
Adjustment shim thickness:
0.3 mm (0.012 in), 0.4 mm (0.016 in),
0.5 mm (0.020 in), 0.6 mm (0.024 in),
0.7 mm (0.028 in)
3. Apply oil to the oil seal lip, and install it to the clutch housing with the SST.
