RX7 2RTR- 1308cc 1.3L Turbo FI (1989)
4. Apply sealant to the contacting surfaces of the clutch housing and transmission case.
5. Install the correct adjustment shim on the main drive gear bearing.
6. Install the clutch housing.
Tightening torque: 41 - 55 N-m (4.2 - 5.6 m-kg, 30 - 41 ft-lb)
7. Install the front cover on the clutch housing.
Tightening torque: 7.8 - 11 N-m (80 - 110 cm-kg, 69 - 95 in-lb)
Locknut
1. Install a new snap ring, the steel ball, and the dynamic damper.
2. Set the taper cotters between the mainshaft and dynamic damper.
NOTE: Use pads in the vise to prevent damaging the SST.
