RX7 2RTR- 1308cc 1.3L Turbo FI (1989)
3. Connect the SST to the mainshaft and tighten it securely in a vise.
4. Install the locknut with the SST.
Tightening torque (without SST): 157 - 206 N-m (16 - 21 m-kg, 116 - 152 ft-lb)
Tightening torque (with SST):
5. Install a new snap ring to secure the locknut.
Extension housing
1. Apply sealant to the contact surfaces of the extension housing and change control case.
2. Install the change control case.
Tightening torque: 22 - 30 N-m (2.2 - 3.1 m-kg, 16 - 22 ft-lb)
3. Install the oil passage.