RX7 2RTR- 1308cc 1.3L Turbo FI (1989)
2. Measure the mainshaft front bearing height. The difference between the two measurements indicates the required thickness of the adjustment shim.
Standard thrust play: 0 - 0.1 mm (0 - 0.004 in)
Adjustment shim thickness: 0.1 mm (0.004 in), 0.3 mm (0.012 in)
Countershaft front bearing
1. Measure depth B of the countershaft front bearing bore in the transmission case.
2. Measure the countershaft front bearing snap ring height A.
3. Choose an adjustment shim that will allow the difference between the two measurements to be equal to the standard bearing height.
A - B + Adjustment shim(s) = 0.9 - 1.0 mm (0.035 - 0.039 in)
Standard bearing height on installing: 0.9 - 1.0 mm (0.035 - 0.039 in)
Adjustment shim thickness: 0.1 mm (0.004 in), 0.3 mm (0.012 in)
Transmission case
1. Position the 1st and 2nd shift forks and 3rd and 4th shift forks into the grooves of the clutch hub and sleeve assemblies.
2. Apply molybdenum grease to the needle bearing and install it in the main drive gear.
3. install the main drive gear onto the front of the mainshaft.
