mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Engine Controls - Lack of Engine Power|Page 2367 > < Engine Controls - Lack of Engine Power|Page 2365
Page 6
background image

D.

Click on "+ arrow up" symbol until MOP POS # indicates "60".

22.

Allow engine to idle for 15 minutes with MOP POS # at step 60.

NOTE:

^

Make sure transmission is in NEUTRAL or PARK and all loads OFF (AC, blower etc.), do not touch accelerator pedal during this time or
test will abort.

23.

Tap accelerator pedal after the 15 minutes have elapsed to abort test. MOP POS # will drop from step # 60.

24.

Turn engine off.

25.

Connect the secondary air injection pump connector B1-04.

B - Test Drive

B - TEST DRIVE

1.

Perform test drive lasting at least 40 minutes following these guidelines:

^

Drive vehicle on city streets at speeds below 45 MPH.

^

Air conditioning and fan speed on max.

^

Accelerate at very light throttle keeping shift points below 3000 RPM. After 20 minutes stop vehicle in a parking lot, M/T in neutral and A/T
in drive for one minute, and monitor engine RPM using the DATALOGGER PID.

^

At the 40 minute mark, stop the vehicle in a parking lot, M/T in neutral and A/T in drive for one minute, and monitor engine RPM using the
DATALOGGER PID.

^

Safely accelerate the vehicle at wide open throttle (M/T shift at 8000 RPM) to the legal speed limit.

2.

Did you experience any of the following during the test drive?

^

The vehicle has a lack of power

Engine Controls - Lack of Engine Power|Page 2367 > < Engine Controls - Lack of Engine Power|Page 2365