RX8 2RTR-1.3L (2006)
Transmission Position Switch/Sensor: Adjustments
[SJ6A-El] Automatic Transmission/Transaxle
TRANSMISSION RANGE (TR) SWITCH ADJUSTMENT [SJ6A-EL]
Caution:
^
Water or foreign material entering the connector can cause poor connections or corrosion. Be sure that water or foreign material do not
enter the connector when disconnecting it.
1. Remove the engine cover.
2. Remove the battery cover.
3. Disconnect the negative battery cable.
4. Remove the front tunnel member.
5. Remove the rear tunnel member.
6. Remove the catalytic converter.
7. Remove the insulator.
8. Mark the manual shaft lever component as shown in the figure.
9. Separate the manual shaft lever/component from selector lever.
10. Disconnect the TR switch connector.
11. Rotate the manual shaft to the N position.
Caution:
^
Do not use an impact wrench. Hold the manual shaft lever when removing the manual shaft nut, otherwise the transmission may be
damaged.
