RX8 2RTR-1.3L (2006)
Technical Service Bulletin # 0101408
Date: 080317
Engine Controls - Lack of Engine Power
Bulletin.: 01-014/08
Last Issued: 3/17/2008
Subject:
ENGINE LACK OF POWER
BULLETIN NOTE
This bulletin supersedes the previous bulletin 01-014/08, issued 3/14/2008. The DESCRIPTION has been revised.
APPLICABLE MODEL(S)/VINs
2004-2008 RX-8
DESCRIPTION
Some customers may experience a lack of engine power and an low engine idle speed during high ambient temperatures. This may be caused by poor
sealing of rotor chambers due to an accumulation of carbon on the rotor housing trocoid surface. This is caused by a lack of metering oil lubrication
during engine start or insufficient ignition timing under high ambient temperature condition. A revised PCM calibration is available which increases
metering oil lubrication amount during engine start. Ignition timing under high ambient temperature is recalibrated as well.
Customers who are currently experiencing a lack of engine power and low engine idle speed should have their vehicle repaired using the following repair
procedure.
IMPORTANT:
^
BEFORE PERFORMING THE REPAIR PROCEDURE, ENSURE THE FOLLOWING ITEMS HAVE FOLLOWING ITEMS HAVE
BEFORE PERFORMING THE REPAIR PROCEDURE, ENSURE THE FOLLOWING ITEMS HAVE BEEN COMPLETED:
-
EMISSION RECALL 4206F
-
MAZDA SPECIAL PROGRAM (MSP16) ENGINE LACK OF POWER
REPAIR PROCEDURE
There are many possible concerns which may cause lack of power symptoms. The focus of this Service Bulletin is assisting diagnosis of concerns related
to the Rotary Engine internal components. While it is impractical to list all possible causes in this Service Bulletin, please inspect the following common
concerns which may cause lack of power symptoms before proceeding to "Engine Inspection".
^
CATALYTIC CONVERTER - Restriction of the exhaust system due to catalyst failure may cause lack of power symptoms. Check MODE 6 ON
BOARD TEST RESULTS and verify catalyst efficiency is within specification.
^
IGNITION COILS - Non-functioning ignition coils may cause lack of power symptoms. Inspect ignition coils using Service Bulletin 01-016/07
"IGNITION COIL INSPECTION". Replace non-functioning ignition coils and test drive the vehicle to confirm lack of power symptom has been
repaired.
Is the measured test result "VALUE" number MORE or LESS than 4.60:1?
-
LESS THAN 4.60:1 - Catalytic converter OK, replacement is NOT necessary.
-
MORE THAN 4.60:1 - Catalytic converter failed, replace catalytic converter and check exhaust system for restriction by broken material. Test drive
the vehicle to confirm lack of power symptom has been repaired.
^
SECONDARY SHUTTER VALVE (SSV) - Lack of power may be caused by a stuck-closed Secondary Shutter Valve (SSV). This condition
prevents intake airflow into the engine during mid and high RPM. Confirm the SSV moves freely and is not stuck in the closed position. The vehicle
may also have P2070 (SSV stuck open) stored in PCM memory. Review Electronic Service Information for the latest Service Bulletins and / or
consult workshop manual for current repair procedures.
Lack of power symptoms typically occur during hot ambient temperature conditions. Please perform the following engine diagnostics tests when the
customer has a current lack of power complaint and / or during hot ambient temperatures for accurate results AFTER inspecting the above listed
components.
-
A - CARBON REMOVAL PROCEDURE
