RX8 2RTR-1.3L (2006)
24. Inspect for continuity between TR switch terminals E and H.
25. Install the manual shaft lever component and washer.
Caution:
^
Do not use an impact wrench. Hold the manual shaft lever when tightening the manual shaft nut, otherwise the transmission may be
damaged.
26. Set the adjustable wrench as shown in the figure to hold the manual shaft lever.
27. Tighten the manual shaft nut using a torque wrench.
Tightening torque 13.7-17.6 N-m (1.4-1.8 kgf-m, 11-13 ft-lbf)
28. Shift the selector lever to the P position.
29. Turn the manual shaft lever to the P position.
30. Inspect TR switch continuity. (See Transmission Range (TR) Switch Inspection [SJ6A-EL].) See: Transmission Control Systems/Testing and
Inspection/Component Tests and General Diagnostics/[SJ6A-El] Automatic Transmission/Transaxle/Transmission Range (TR) Switch Inspection
31. Connect the TR switch connector.
32. Align the mark of the manual shaft lever component as shown in the figure.
33. Install the manual shaft lever component installation nut.
Tightening torque 10.8-14.7 N-m (11.1-11.4 kgf-m, 8.0-10.8 ft-lbf)