RX8 2RTR-1.3L (2006)
8. Disconnect the TR switch connector.
9. Verify continuity as indicated in the table.
^
If there is any malfunction, adjust the TR switch.
10. Reinspect for continuity at TR switch.
^
If there is any malfunction, replace the TR switch.
11. Connect the TR switch connector.
12. Install the insulator.
Tightening torque 8-11 N-m (82-112 kgf-cm, 72-97 in.lbf)
13. Install the catalytic converter.
14. Install the rear tunnel member.
15. Install the front tunnel member.
16. Connect the negative battery cable.
17. Install the battery cover.
18. Install the engine cover.
