RX8 2RTR-1.3L (2006)
7. Measure the resistance between the following terminals.
^
If not within the specification, perform the operating inspection.
8. Connect the solenoid valve connector.
9. Install the insulator.
Tightening torque 8-11 N-m (82-112 kgf-cm, 72-97 in-lbf)
10. Install the catalytic converter.
11. Connect the negative battery cable.
12. Install the battery cover.
13. Install the engine cover.
Operating Inspection
1. Remove the engine cover.
2. Remove the battery cover.
3. Disconnect the negative battery cable.
4. Remove the catalytic converter.
5. Remove the insulator.
