RX8 2RTR-1.3L (2006)
Transmission Position Switch/Sensor: Testing and Inspection
[SJ6A-El] Automatic Transmission/Transaxle
TRANSMISSION RANGE (TR) SWITCH INSPECTION [SJ6A-EL]
Operating inspection
1. Verify that the starter operates only when the ignition switch is turned to the START position with the selector lever in the P or N position.
^
If there is any malfunction, adjust the TR switch.
2. Verify that the back-up lights illuminate when shifted to the R position with the ignition switch at the ON position.
^
If there is any malfunction, adjust the TR switch.
3. Verify that the positions of the selector lever and the indicator are aligned.
^
If there is any malfunction, adjust the TR switch.
Continuity Inspection
Caution:
^
Water or foreign material entering the connector can cause poor connections or corrosion. Be sure that water or foreign material do not
enter the connector when disconnecting it.
1. Remove the engine cover.
2. Remove the battery cover.
3. Disconnect the negative battery cable.
4. Remove the front tunnel member.
5. Remove the rear tunnel member.
6. Remove the catalytic converter.
7. Remove the insulator.
