Tribute 2WD L4-2.3L (2005)
For 2001-2004 model year vehicles, proceed to Step 4. For 2005 model year vehicles, begin this repair from Step 1.
1.
Open the liftgate.
2.
If equipped, remove the rear wiper motor cover.
3.
Remove the four (4) screws and remove the liftgate trim panel.
4.
Disconnect the liftgate ajar switch electrical connector (located on the liftgate switch).
5.
Remove the three (3) liftgate latch bolts and retain.
6.
Remove the liftgate latch.
7.
Remove the liftgate latch release rod and install the new rod.
8.
Remove the original release rod clip and replace with the new clip.
LIFTGATE LATCH INSTALLATION
AFFECTED VEHICLES:
ALL VEHICLES COVERED BY RECALL 2804L
1.
Position the latch assembly in the vehicle.
2.
Apply (locally obtained) Permatex Medium Strength Thread locker (blue), to the bolts and install the three (3) liftgate latch bolts.
Tightening Torque: 5 Nm (44 lb-in)
3.
Connect the liftgate ajar switch electrical connector.
NOTE:
For 2001-2004 model year vehicles, proceed to "Liftgate Handle Installation." For 2005 model year vehicles, proceed to Step 4.
4.
Install the liftgate trim panel and four (4) screws.
5.
If equipped, install the rear wiper motor cover.
6.
Close the liftgate.