Recall: Liftgate Latch Non-Compliance - Tribute 2WD L4-23L
7.
Disconnect the liftgate handle-to-remote release rod from the remote control assembly, then remove the remote control.
8.
Remove the liftgate handle assembly and place it on a bench.
9.
Disassemble the handle as follows:
a.
Remove the circlip from the end of the pivot rod.
b.
Pull the pivot rod out of the handle assembly.
c.
Note the position of the spring then remove the spring from the handle assembly.
10.
Install the new spring and circlip to the original pivot rod and handle.
NOTE:
The new circlip is supplied in the bag with the new spring. Make sure to retain the new circlip for installation to the original pivot rod and
handle.
LIFTGATE LATCH REMOVAL AND RELEASE ROD REPLACEMENT
AFFECTED VEHICLES:
ALL VEHICLES COVERED BY RECALL 2804L
NOTE:
