Tribute 2WD L4-2.3L (2005)
NOTE: Verify Recall number as the vehicle may have multiple recalls.
eMDCS System - Warranty Vehicle Inquiry Results
OVERVIEW
This program involves inspecting the structural foam blocks mounted at the front corners on the top of the headliner. If necessary, the foam blocks
will be modified by drilling two (2) holes in each block with a supplied drill guide and auger drill bit.
The purpose of this modification is to bring the foam blocks into compliance with FMVSS 201, Occupant Protection in Interior Impact. Vehicles
equipped with a moonroof or side air curtains are not involved.
B. REPAIR PROCEDURE
CAUTION: Failure to perform all disassembly steps as outlined increases the possibility of damaging the headliner.
CAUTION: Make sure your hands are clean before performing this repair.
NOTE: Although the headliner does not have to be removed to carry out the inspection or modification, a number of trim panels and components
must be removed or repositioned in order to lower the front of the headliner for access. Performing all steps as outlined will position the headliner
adequately for access to the repair area.
NOTE: If the vehicle is equipped with any aftermarket or dealer-installed options, such as a DVD player which interferes with adequately lowering
the headliner, they must be removed.
DISASSEMBLY FOR INSPECTION:
NOTE: Perform the following steps on both sides of the vehicle.
1. Open the A-pillar assist handle bolt covers, then remove the bolts and the assist handles.
2. Remove the A-pillar trim panels.
3. At the B-pillars, remove the D-ring covers and safety belt bolts.
