Tribute 2WD L4-2.3L (2005)
Brake Pad: Service and Repair
Rear
BRAKE PADS - REAR
Removal and Installation
1. Remove the brake caliper guide bolts.
Caution: Do not allow the brake caliper to hang by the flexible brake hose.
Note: It is not necessary to remove the flexible brake hose.
2. Remove the brake caliper and support the caliper to the vehicle.
3. Remove the brake pads.
Note: If installing new brake pads, remove brake fluid from the master cylinder reservoir using a suitable suction device until the reservoir is half
full.
4. If installing new brake pads, fully retract the brake caliper pistons.
5. To install, reverse the removal procedure.
^
Lubricate the brake caliper guide bolts with silicone grease.
