Tribute 2WD L4-2.3L (2005)
7. Remove the RH splash shield.
8. If equipped, disconnect the engine block heater electrical connector.
9. Disconnect the A/C clutch field coil electrical connector.
CAUTION: Plug all ports to prevent contamination from dirt or moisture.
10. Remove the A/C manifold and tube assembly bolt.
11. Remove the A/C manifold and tube assembly through the bottom of the vehicle.
12. To install, reverse the removal procedure.
-
Lubricate the O-ring seals with PAG Compressor Oil.
-
Apply Pipe Sealant with Teflon« to the threads of the A/C manifold retaining bolt.