Tribute 2WD L4-2.3L (2005)
deactivate the fans. Fuel pump is a mini fuse 20 amp (position #6) at front end of fuse box.
14. Screen shows a "progress bar" on the bottom of the screen and "Please wait".
15. Screen shows "Set ignition switch to the ON position". Turn ignition switch to the ON position. Press tick.
16. Screen shows "Downloading data" box with "progress bar". Please wait 2-3 minutes.
17. Screen now shows "Set ignition switch to the OFF position". Turn ignition switch to the OFF position. Press tick.
18. Screen now shows "Set ignition switch to the ON position". Turn ignition switch to the ON position. Press tick.
19. Screen now shows "Set ignition switch to the OFF position". Turn ignition switch to the OFF position. Press tick.
20. Screen shows "Calibration has been loaded and checked". Press tick.
21. Screen shows "Re-install fuses for fuel pump and additional fans". Re-install fuses for fuel pump and additional fans. Press tick.
22. Screen shows "Obtain a PCM label and fill in the PCM data shown with the date on the WDS or equivalent tester screen. Install in the appropriate
position (New label should be in the new PCM part box). Press tick.
23. Screen shows "start engine. Do not depress throttle". THIS IS INCORRECT! You must follow the procedure below to start the vehicle.
-
Turn Key ON, Engine OFF (KOEO) (Count 3 secs security is ON solid), remove key.
-
Insert 2nd key, turn key ON, (security stay ON for 3 secs goes out) turn key OFF. Then start engine Turn OFF engine, remove key.
-
Both keys programmed.
24. Disconnect WDS or equivalent tester from vehicle. PCM replacement procedure is completed.
