mazda Workshop Repair Guides

Mazda Workshop Service and Repair Manuals

Arming and Disarming|Page 3961 > < Arming and Disarming
Page 2
background image

4. Connect the negative battery cable.
5. Prove out the supplemental restraint system (SRS) as follows.

Turn the ignition key from ON to OFF Wait 10 seconds, then turn the key back to ON and visually monitor the air bag indicator with the air bag
modules installed. The air bag indicator will light continuously for approximately six seconds and then turn off. If an air bag supplemental
restraint system (SRS) fault is present, the air bag indicator will either
-

fail to light.

-

remain lit continuously.

-

flash.

The flashing might not occur until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON position. This is
the time required for the restraints control module (RCM) to complete the testing of the SRS. If the air bag indicator is inoperative and a SRS
fault exists, a chime will sound in a pattern of five sets of five beeps. If this occurs, the air bag indicator and any SRS fault discovered must be
diagnosed and repaired.

Clear all continuous DTCs from the restraints control module using a scan tool.

Arming and Disarming|Page 3961 > < Arming and Disarming