Tribute 2WD L4-2.3L (2005)
8. Install the pivot nut.
9. Route the side air bag wire harness, as noted in removal, and install the wire harness and electrical connector pin-type retainers.
10. Install the outboard seat cushion side shield.
1. Align the retaining clips and push inward, seating the retaining clips.
-
If equipped, connect the power seat switch electrical connector.
2. Install the screw.
3. Install the seat backrest lever cover.
11. Align the retaining clips and push inward, installing the inboard seat cushion side shield.
CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle may result
in damaged components.
NOTE: Make sure to follow all steps and instructions in the installation procedure of the affected seat.
12. Install the affected seat into the vehicle. See DRIVER SEAT, or PASSENGER SEAT, Repower the system. See SUPPLEMENTAL RESTRAINT
SYSTEM (SRS) DEPOWERING AND REPOWERING.
