Tribute 2WD L4-2.3L (2005)
WARNING: The restraint system diagnostic tool is for restraint system repair only. Remove from vehicle prior to road use. Failure to remove
could result in injury and possible violation of vehicle safety standards.
NOTE: If a seat equipped with a seat-mounted side air bag and/or a safety belt pretensioner (if equipped) system is being serviced the air bag system
must be depowered. See SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING.
NOTE: Restraint system diagnostic tools MUST be installed under the seats in the side air bag and safety belt pretensioner (if equipped) to floor
connectors.
NOTE: If a seat equipped with a seat-mounted side air bag and/or a safety belt pretensioner (if equipped) system is being serviced, the supplemental
restraint system (SRS) must be depowered.
NOTE: After diagnosing/repairing a seat system the restraint system diagnostic tools must be removed before operating the vehicle over the road.
NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
NOTE: The driver seat safety belt buckle and pretensioner is shown, the passenger-side is similar.
1. Install the safety belt buckle and pretensioner.
1. Position the safety belt buckle and pretensioner to the seat cushion frame.
2. Align and install the anti-rotation tab of the safety belt buckle and pretensioner to the slot in the seat cushion frame.
3. Using the special tool, install the bolt.
NOTE: Note the wire harness routing for installation.
2. Route the safety belt buckle and pretensioner wire harness, as noted in removal, and install the wire harness and electrical connector pin-type
retainers.
3. Align the retaining clips and push in, installing the inboard seat cushion side shield.
CAUTION: Use care when handling the seat and track assembly. Dropping the assembly or sitting on a seat not secured in the vehicle may result
in damaged components.
