Tribute 2WD L4-2.3L (2005)
removed from the vehicle and the restraint system diagnostic tools must be installed in the side air bag and the safety belt pretensioner (if equipped)
connectors at the floor connectors. The restraint system diagnostic tools must be removed prior to operating the vehicle over the road.
NOTE: Diagnostics may be performed on seat systems other than the side air bag or the safety belt pretensioner (if equipped) system (lumbar, climate
controlled, heated, power seat track) with the seat installed in the vehicle as long as the restraint system diagnostic tools are installed under the seats in
the side air bag and safety belt pretensioner to floor connectors.
NOTE: After diagnosing/repairing a seat system the restraint system diagnostic tools must be removed before operating the vehicle over the road.
NOTE: Repair is made by installing a new part only if the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
WARNING: The tightening torque of the air bag side crash sensor retaining bolts is critical for proper system operation. Failure to follow
these instructions may result in personal injury.
1. Install the side crash sensor
1. Position the side crash sensor to the B-pillar.
2. Install the bolts.
3. Connect the side crash sensor electrical connector.
2. Repower the system. See SUPPLEMENTAL RESTRAINT SYSTEM (SRS) DEPOWERING AND REPOWERING.
3. Install the B-pillar trim panel.
