Tribute 2WD L4-2.3L (2005)
-
Before disconnecting connectors or removing electrical parts, disconnect the negative battery cable.
Wiring Harness
-
To remove the wiring harness from the clip in the engine room, pry up the hook of the clip using a flathead screwdriver.
CAUTION: Do not remove the Harness protective tape. Otherwise, the wires could rub against the body, which could result in water penetration
and electrical shorting.
CONNECTORS
Data Link Connector
-
Insert the probe into the terminal when connecting a jumper wire to the data link connector.
CAUTION: Inserting a jumper wire probe into the data link connector terminal may damage the terminal.
Disconnecting Connectors