Tribute 2WD L4-2.3L (2005)
9. Through the glove compartment opening, connect the passenger air bag module electrical connector.
10. Close the glove compartment.
11. Remove the restraint system diagnostic tool from the air bag sliding contact electrical connector at the top of the steering column.
12. Connect and install the driver air bag module electrical connector.
1. Connect the driver air bag module electrical connector.
2. Through the steering wheel access cover opening, slide the driver air bag module electrical connector onto the pin-type retainer.
13. Install the steering wheel access cover.
WARNING: The restraint system diagnostic tool is for restraint system service only. Remove from vehicle prior to road use. Failure to
remove could result In injury and possible violation of vehicle safety standards.
14. Make sure all restraint system diagnostic tool(s) that may have been installed during the repair have been removed from the vehicle and all SRS
components are connected.
15. Turn the ignition switch from OFF to ON.
WARNING: Be sure that nobody is in the vehicle and that there is nothing blocking or set in front of any air bag module when the
negative battery cable is connected.
