Tribute 2WD L4-2.3L (2005)
Note: Make sure the pump support seal rings are overlapped correctly.
8. Install the seven pump support seal rings.
9. Measure the pump rotational torque.
1. Install the pump drive shaft.
2. Measure the pump rotational torque.
3. Remove the pump drive shaft.
4. If rotational torque exceeds the specification, disassemble and inspect the pump assembly for contamination or incorrect end clearance.
10. Install the No.1 pump support thrust bearing.
Lubricate the seal rings with clean automatic transaxle fluid.
11. Install the forward/coast/direct clutch cylinder and reverse clutch drum on the pump support.
Warning: Air pressure must not exceed 138 kPa (20 psi). Wear safety glasses when using compressed air. Failure to follow these instructions
