Tribute 2WD L4-2.5L (2009)
Brake Hose/Line: Service and Repair
Brake Flexible Hose - Drum Removal/Installation
-
BRAKE FLEXIBLE HOSE - DRUM REMOVAL/INSTALLATION
WARNING:Do not use any fluid other than clean brake fluid meeting manufacturer's specification. Additionally, do not use brake fluid that has been
previously drained. Following these instructions will help prevent system contamination, brake component damage and the risk of serious personal
injury.
WARNING:Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. For
additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious
personal injury.
CAUTION:Do not spill brake fluid on painted or plastic surfaces or damage to the surface may occur. If brake fluid is spilled onto a painted or plastic
surface, immediately wash it with water.
1. Disconnect the flexible hose fitting from the wheel cylinder.
-
To install, tighten to 18 Nm {1.8 kgf-m, 159 in-lbf}.
2. Remove the brake flexible hose bracket bolt.
-
To install, tighten to 15 Nm {1.5 kgf-m, 133 in-lbf}.
3. Disconnect the brake tube fitting from the brake flexible hose.
-
To install, tighten to 18 Nm {1.8 kgf-m, 159 in-lbf}.
4. Remove the flexible hose clip and the brake hose.
5. To install, reverse the removal procedure.
-
Bleed the wheel cylinder. See See: Brake Bleeding/Service and Repair/Component Bleeding.
