Tribute 2WD L4-2.5L (2009)
10 (6). When these pins are grounded, the windshield wiper motor operation should now be in low speed mode.
High Speed
Test the high speed mode by connecting a separate set of test leads from battery ground (-) post to windshield wiper motor (4) component side pins 1, 9,
and 10 (7). When these pins are grounded, the windshield wiper motor operation should now be in high speed mode.
Washer Pump Relay (Integral)
Test the windshield wiper motor internal washer relay function by measuring the voltage between windshield wiper motor (4) component side pin 7 (8),
and ground while grounding the windshield wiper motor (4) component side pin 12 (9). When wash command input pin 12 is grounded, measured
voltage should read 10 volts or greater.