Tribute 2WD V6-3.0L (2008)
8. Squeeze together the tip of each head restraint guide and remove from the backrest frame.
NOTE:
-
The inboard and outboard head restraint guides are not interchangeable.
-
The head restraint guides incorporate an alignment tab that must be aligned correctly when installed.
9. For the 60 percent backrest, remove the 2 screws and the safety belt shield.
10. Separate the hook-and-loop strips and remove the seat backrest trim cover.
CAUTION: Use care when separating the seat backrest trim cover from the hook-and-loop strip or the hook-and-loop strip can be torn
from the seat backrest foam pad.
11. To install, reverse the removal procedure.
-
Make sure the safety belts and buckles are accessible to the occupants after installation.
-
For 60 percent seat, verify the safety belt retractor operates without excessive effort or binding.
