Tribute 2WD V6-3.0L (2008)
7. Verify that the anchor housing spring is correctly latched by pulling on the spring.
Note
^
The latch MUST be positioned as shown.
8. Install the brake flexible hose to the brake caliper.
^
Tighten to 20 N-m (2.0 kgf-m, 15 ft-lbf).
Note
^
Make sure that the brake flexible hose is not twisted.
9. Install the wheel and tire assembly.
10. Bleed the brake system.
BRAKE CALIPER ANCHOR PLATE REMOVAL/INSTALLATION
1. Remove the wheel and tire assembly.
2. Remove the 2 brake caliper guide pin bolts and position the caliper aside.
^
Support the caliper using mechanic's wire.
3. Remove the 2 brake caliper anchor plate bolts.
^
To install, tighten to 175 N-m (17.8 kgf-m, 129 ft-lbf).
4. Remove the brake caliper anchor plate.
5. To install, reverse the removal procedure.
