Tribute 2WD V6-3.0L (2008)
4. Rotate the spring upward and remove it from the brake caliper.
5. For the RH brake caliper, release the upper portion of the brake pad anti-rattle spring.
^
Apply force to the center of the spring and pull outward at the top of the spring to remove it from the upper brake caliper cavity.
Note
^
The RH side brake pad anti-rattle spring must be installed with the 2-tabbed end in the lower brake caliper cavity.
6. Rotate the spring downward and remove it from the brake caliper.
7. Remove the 2 guide pin bushing caps and the 2 brake caliper guide pin bolts, position the caliper aside.
^
Support the caliper using mechanic's wire.
Caution
^
Do not allow the caliper to hang from the brake hose or damage to the hose can occur.
8. Remove the 2 brake pads from the caliper.
9. Inspect the brake pads for wear and contamination, install new pads as necessary.
10. Compress the brake caliper piston into the brake caliper.
Note
^
Use a suitable tool to protect the brake caliper piston boots.
11. Inspect the brake disc and resurface or install new as necessary.
Installation
1. Clean, dry and inspect the brake caliper anchor plate. Apply a light coat of specified lubricant to the 4 brake pad contact points on the anchor
plate.
2. Install the brake pads onto the caliper and position the brake caliper onto the anchor plate.
^
Make sure that the brake flexible hose is not twisted.
Note
^
Make sure that the brake flexible hose is not twisted.
3. Install the 2 brake caliper guide pin bolts and the 2 bushing caps.
