Tribute 2WD V6-3.0L (2008)
Wheel Cylinder: Removal and Replacement
WHEEL CYLINDER REMOVAL/INSTALLATION
Warning
^
Use of any other than approved DOT 3 motor vehicle brake fluid will cause permanent damage to brake components and will render
the brakes inoperative. Failure to follow these instructions may result in personal injury.
Warning
^
Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical advice. For
additional information, consult the product Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may
result in personal injury.
Caution
^
Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it
with water.
1. Remove the rear brake shoes.
2. Disconnect the brake tube fitting.
^
To install, tighten to 15 N-m (1.5 kgf-m, 11 ft-lbf).
3. Remove the 2 wheel cylinder bolts and remove the wheel cylinder.
^
To install, tighten to 11 N-m (1.1 kgf-m, 8 ft-lbf).
4. To install, reverse the removal procedure.
^
Bleed the brake hydraulic system.
