Tribute 2WD V6-3.0L (2008)
13. Install the RH timing chain tensioner and tensioner arm.
(1) Install the tensioner arm.
(2) Position the tensioner.
(3) Install the bolts.
1) Tighten to 25 N-m (2.5 kgf-m, 18 ft-lbf).
14. Remove the LH and RH timing chain tensioner piston retaining wires.
15. Rotate the crankshaft counterclockwise 120 degrees to top dead center (TDC).
16. Verify the timing with the following steps.
(1) There should be 12 chain links between the camshaft timing marks.
(2) There should be 27 chain links between the camshaft and crankshaft timing marks.
(3) There should be 30 chain links between the camshaft and crankshaft timing marks.
Caution
^
Failure to verify correct timing drive component alignment will result in severe engine damage.
17. Remove the crankshaft pulley bolt.
