Tribute 2WD V6-3.0L (2008)
Hose/Line HVAC: Service and Repair
Compressor to Condenser Line - 3.0L Removal/Installation
COMPRESSOR TO CONDENSER LINE - 3.0L (4V) REMOVAL/INSTALLATION
NOTE: Installation of a new suction accumulator is not required when repairing the air conditioning system, except when there is physical evidence of
contamination from a failed A/C compressor or damage to the suction accumulator.
1. With the vehicle in NEUTRAL, position it on a hoist. See LIFTING.
2. Recover the refrigerant. See DISCHARGING AND RECOVERY.
3. Remove the RH lower engine splash shield.
4. Remove the front bumper cover.
5. Remove the condenser inlet fitting nut and disconnect the fitting.
-
Discard the O-ring seal and gasket seal.
-
To install, tighten to 15 N.m (1.5 kgf.m, 11 ft.lbf).
