Tribute 2WD V6-3.0L (2008)
Crankshaft Position Sensor: Service and Repair
CRANKSHAFT POSITION (CKP) SENSOR - 3.0L (4V) REMOVAL/INSTALLATION
1. With the vehicle in NEUTRAL, position it on a hoist. See LIFTING.
2. Remove the 5 bolts and the RH splash shield.
-
To install, tighten to 9 N.m {0.9 kgf.m, 80 in.lbf}.
3. Disconnect the crankshaft position (CKP) sensor electrical connector.
4. Remove the bolt and the CKP.
-
To install, tighten to 10 N.m {1.0 kgf.m, 89 in.lbf}.
-
Inspect the O-ring seal and install new as necessary.
5. To install, reverse the removal procedure.
NOTE: Lubricate the CKP O-ring seal with clean engine oil.
