Tribute 2WD V6-3.0L (2008)
2. Position a suitable lifting device under the fuel tank.
3. Remove the LH fuel tank bolt and strap.
-
To install, tighten to 55 N.m {5.6 kgf.m, 41 ft.lbf}.
4. Partially lower the LH side of the fuel tank enough to access the fuel vapor tube assembly.
5. Disconnect the fuel pump (FP) module and fuel tank pressure (FTP) sensor electrical connector.
6. Disconnect the fuel vapor tube assembly-to-fuel tank quick connect coupling.
7. Disconnect the fuel vapor tube assembly-to-evaporative emission (EVAP) canister quick connect coupling.
8. Disconnect the fuel vapor tube assembly-to-fuel vapor tube assembly quick connect coupling.
9. Release the retainer clip and remove the fuel vapor tube assembly.
10. To install, reverse the removal procedure.
-
Carry out a leak test. See EVAPORATIVE EMISSION SYSTEM LEAK TEST. See: Leak Detector/Testing and Inspection
-
Carry out the evaporative emission repair verification drive cycle. See EVAPORATIVE EMISSION REPAIR VERIFICATION DRIVE
CYCLE. See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes
