Tribute 2WD V6-3.0L (2008)
Accelerator Pedal: Service and Repair
ACCELERATOR PEDAL AND SHAFT - 3.0L (4V) REMOVAL/INSTALLATION
WARNING: Make sure surrounding components such as wiring, hoses, sound insulation and floor carpeting are not contacting the sliding
inner cable of the accelerator cable or the accelerator pedal and shaft. Failure to follow these instructions may result in serious personal injury
to the vehicle occupant(s).
NOTE: The accelerator pedal and shaft should travel smoothly from idle to wide-open throttle positions. Hesitation on return or prevention of return to
the idle position must not occur.
1. Remove the accelerator cable from the accelerator pedal.
2. Remove the 2 bolts and the accelerator pedal and shaft assembly.
-
To install, tighten to
9 N.m {0.9 kgf.m, 80 in.lbf}.
3. To install, reverse the removal procedure.
