Tribute 2WD V6-3.0L (2008)
1. Rotate the lock tab and install the quick connect coupling onto the fitting.
NOTE: Apply clean engine oil to the end of the tube and the quick connect coupling O-ring seals.
2. Release the lock tab into the latched position.
NOTE: Make sure the fuel tube clicks into place when installing the tube. To make sure that the fuel tube is fully seated, pull on the tube.
Disconnect - Type III
WARNING:
-
Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel-related components. Highly
flammable vapors are always present and can ignite. Failure to follow these instructions may result in serious personal injury.
-
Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any
fuel-related components. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may
result in serious personal injury.
-
Fuel in the fuel system remains under high pressure, even when the engine is not running. Before servicing or disconnecting any of the
fuel lines or fuel system components, the fuel system pressure must be relieved to prevent accidental spraying of fuel. Failure to follow
these instructions may result in serious personal injury.
1. If servicing a liquid fuel tube quick connect coupling, release the fuel system pressure. See FUEL SYSTEM PRESSURE RELEASE.
