Tribute 2WD V6-3.0L (2008)
Oil Pressure Switch (For Fuel Pump): Service and Repair
ENGINE OIL PRESSURE (EOP) SWITCH - 3.0L (4V) REMOVAL/INSTALLATION
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the pin-type retainer, 5 bolts and the RH lower splash shield.
^
To install, tighten to 9 N-m (0.9 kgf-m, 80 in-lbf).
3. Remove the engine oil filter.
^
To install, tighten to 5 N-m (0.5 kgf-m, 44 in-lbf) and then rotate an additional 180 degrees.
Note
^
Lubricate the engine oil filter gasket with clean engine oil prior to installing.
4. Disconnect the engine oil pressure (EOP) switch electrical connector.
5. Remove the EOP switch.
^
To install, tighten to 14 N-m (1.4 kgf-m, 10 ft-lbf).
6. To install, reverse the removal procedure.